finallygotmyheresies Posted February 10, 2015 Share Posted February 10, 2015 (edited) Just a general question for people with crossover building experience. I have never built nor modified a crossover before but I'm not afraid to try. Looking at this schematic that JWC provided for me does this seem like a easy, entry level network to build? I have a solder station already so I'd just need the parts and a board to mount them to. Thanks p.s. looking at this it might as well be in braille since none of it makes any sense to me right now. Edited February 10, 2015 by finallygotmyheresies Quote Link to comment Share on other sites More sharing options...
Paducah Home Theater Posted February 10, 2015 Share Posted February 10, 2015 It wouldn't be too bad but for the life of me I can't remember what that numbered coil on the left is. Quote Link to comment Share on other sites More sharing options...
Axz Hout Posted February 10, 2015 Share Posted February 10, 2015 i 1 Quote Link to comment Share on other sites More sharing options...
Axz Hout Posted February 10, 2015 Share Posted February 10, 2015 s Quote Link to comment Share on other sites More sharing options...
mustang guy Posted February 11, 2015 Share Posted February 11, 2015 Here are some ideas for the LF section, or perhaps the whole network. Sorry I don't have the KP-456, but here are the KP-450 and the KPT-904 networks: KP 450 HF.pdfKP 450 LF.pdf KPT-904B.pdf Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.