acex2 Posted May 17, 2004 Share Posted May 17, 2004 Whats the Threaded Insert Size for the RS-35 and the RB-25. My RS-35 (Sides) and RB-25 (rears)are about 7-8 feet up from the floor, is this OK, or should I angle them all down towards the sweet spot? Thanks Quote Link to comment Share on other sites More sharing options...
justin_tx_16 Posted May 18, 2004 Share Posted May 18, 2004 most speakres use a 22thread I think... if they can't be at eat level, yes, try to aim them towards where your ears will be... which reads funny especially since these are horn speakers (well the tweeter is) you should make sure they are at ear level or aimed towards you. Quote Link to comment Share on other sites More sharing options...
Steve W. Bailey Posted May 18, 2004 Share Posted May 18, 2004 The RS-35 and RB-25 both have a factory installed 1/4x20 threaded insert. 7-8 feet up is pretty high and I would angle down slightly shooting just overhead but not aimed at the ears. Is this the only option for location or can you lower them down to 6 feet or so? Quote Link to comment Share on other sites More sharing options...
acex2 Posted May 18, 2004 Author Share Posted May 18, 2004 Thanks for the reply. No option to move to a 6' hight, sliding door in the way. Sounds like some kind of angled speaker mounts is what I need, I'll take a look at parts-express for them. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.