HERESY RISERS

[ManchesterKhorn]

Hi all out there,

Does anyone have a pdf or the like attachment of plans for Heresy Risers and are there any customs one's out there that work better ?

Best Regards

Lee

[Groomlakearea51]

Easy day!!

Heresy-I's were 13 7/8" wide x 12 1/2" deep x 1" tall; I've also seen 13 3/4" x 12 1/2 as well. They mount flush with the back side, evenly spaced.

Heresy-II's started with the 1" tall as well, however, towards the end, the had a "slant" riser. Same "wide" x "deep" dimensions, BUT, height is/was 2" in front to 1" in back.

Attachment is by four x #8 x 2" panhead screws, recessed into the riser. I would recommend "industrial" velcro so you don't drill holes into the nice bottoms of your Heresy's

Wood is 3/4" thick birch plywood. Veneer is parallel to the length, although I've see vertical....

Veneer to match your actual wood on your Heresy's is available from a number of sources, however, www.joewoodworker.com is a good source.

Glue... Use Heatlock; easy to use; no fumes; simple intructions, etc....

I'm still trying to finish some other projects so I don't have any risers as of yet. I have several folks that want some, and will get to it in a few weeks, if the weather holds up and work slacks off....

Hope that helps.

[greg928gts]

If you are going to make your own risers, you might consider making them like the Heresy III's.

If you are going to veneer them, you can veneer a piece of plywood first, then cut the pieces. Much easier than veneering all the little pieces individually.

Greg