ricktate Posted October 25, 2008 Share Posted October 25, 2008 Im getting ready to work on my Scalas but was wondering about the leading edge of dog house.I dont think the veneer will meet up to a point so my idea is to sand or route it down till about 1/4 wide and use inlay or something.What you guys think? Rick Quote Link to comment Share on other sites More sharing options...
greg928gts Posted October 25, 2008 Share Posted October 25, 2008 Im getting ready to work on my Scalas but was wondering about the leading edge of dog house.I dont think the veneer will meet up to a point so my idea is to sand or route it down till about 1/4 wide and use inlay or something.What you guys think? Rick I don't think you'll have to do that. If you put the veneer on one side and then use a block sander and sand along the plane of the other side, it will make a flat angle at the end of the first piece of veneer. Like a bevel/miter. Then you can put the veneer on the other side and sand that the same way. I've found that the second piece of veneer almost curves just a bit at the end, and the seam between the two is almost invisible. Greg Quote Link to comment Share on other sites More sharing options...
ricktate Posted October 25, 2008 Author Share Posted October 25, 2008 Thanks Greg i was wondering about that to...thanks for the info....Rick Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.