derrickdj1
-
Posts
16486 -
Joined
-
Last visited
-
Days Won
16
Content Type
Forums
Events
Gallery
Posts posted by derrickdj1
-
-
Ceiling speakers should work very well. I have in-surround back in-wall and and ceiling speakers. They work great and replaced other Klipsch speaker that were not in-wall. My only regret is not doing the change earlier and saving some money.
-
Get a pair of RF 7II or RF 7III and be done with it. You need not get another pair of speakers for the rest of your life.
-
2
-
-
The amps from China are great but, if you are happy with the system, you are DONE!
-
It is good to hear you are doing better. You have things under control with the deoxit!
-
3
-
-
Time for a top ten shuffle.
-
1
-
-
Leave auto features active
It uses minimal energy and protects the amp somewhat.
🌝
-
It should go a bit lower: keep both IMO.
-
The RC 64III will offer a bigger sound stage compared to the 4500 center. I use an ext. amp for the front speakers and atmos speakers and use the avr for rest of the speakers. I have been know to run the system to 0 or the max. 😞
-
1
-
-
I have not read any post on using an electronic XO and measurements to align the drivers. Using a passive XO system results in the excess energy from the amp dissipating in heat. The tweeter needs very little power compared to the woofer. I've tried it and switched back to one wire of a nice gauge and sold the extra amp, he, he.🤑
-
Go cheap, it will not make a difference.
-
1
-
-
I would use a XO of 100-80 Hz with all speakers set to small if using a sub. These are small speakers should work well with a XO around 100-80 Hz.
-
It depends on how loud you listen. the room is considered large but, I don't think that is a big problem since you are using a sub. Send pics for a clearer understanding of the space.
Speakers should be set to small when using a sub.
-
Set the speakers to small if that has not been done and do a sub crawl for best placement of the sub.
-
2
-
-
An isolation pad cuts out vibrations, it will not control sound traveling thru walls, floor and ceilings
-
1
-
1
-
-
On 10/5/2019 at 2:27 PM, hootowls said:
I've come to realize that I'm years out of date in documenting the configuration of my main rig. Dual Rythmik sealed subwoofers (E15) have been on the screen wall since May 17. Not shown is a third generic subwoofer on the back wall, which I will someday replace with a Rythmik, possibly an L22 (dual 12-in sealed).
The room looks great!
-
Just use one avr.
-
The speakers are not to large but, should form a triangle equidistant to the main seat. The seat should be off the back wall near the 1/3 mark of the room.
-
They should work well in the back of the room. Good luck.
-
I am an OSU fan and wish Michigan would get back to the status of Michigan teams of the past. It is not much of a rivalry over the past 10 years.
-
1
-
-
Sorry to hear of the lost to your family. May she RIP. Prayers sent.
-
Early this morning it was -23 but, we have warmed up to -18. I will go out to lunch today just to get a taste of frosty, lol.
-
Depending on where you buy your tubes, they may be already burned in.
-
1
-
-
I would not disable MCACC or set the speakers to large. Did you jack-up the bass? Are you in an apartment? You can always listen in the stereo mode late night. Which Pioneer avr do you have?
-
For this question, zero sum gain. In other words, no one correct answer.
-
1
-
Matching 2 different sub woofers
in Subwoofers
Posted
The above is not good advice. Yes, two subs will make the base response better in the room setup properly. The delay does not matter unless they are equal distance and the room is a perfect rectangle without non-symmetrical furnishings . I use multiple subs that are not the same with harmony. See graph attached to the post.