gsxr970

Ok, guess I'll continue using jumpers then. Thanks for your help!! Chad

Issue resolved. I used the jumpers instead. And everything sounds great. I noticed that one of my cable plugs might not have been screwed in properly. So what you're saying is that the additional power I'm sending to the speaker by bi-amping isn't beneficial? Just curious.

Ok, I swapped the cables and the tweeter not working switched sides. I do have 4 Audioquest jumpers so I'll see if that fixes the issue, if not I'll try different speaker cables. Thanks for your help guys!!! I really appreciate it. Chad

Thanks Tasdom, I thought of that after I sent the question. I'll test it in the morning. I'm not using any jumpers, I'm bi-amping these speakers. Chad

Can someone tell me if it's normal for my right and left front speakers to sound completely different from one another? My left speaker's tweeter sounds really muffled compared to my right speaker which sounds crystal clear. Any idea's that might help would be greatly appreciated!! Thanks, Chad

I just purchased the Definitive Technology Supercube Reference, and all I can say it HOLY SHIT!!! These subs are no joke!! I'm surprised though that the 18" only has 500 Watts when the reference model is a 14" sub with 1800 watts.

Thanks guys!!! Sorry I couldn't respond to your help earlier, this forum is not iphone friendly. I should be able to find a stud to mount them with. By the end of the month I hope to have me system up and running!!

What has everyone found to be the best way to hang or mount these speakers to your wall? If you have a specific bolt size and head that would be great, unless someone knows of a mounting bracket that can hold these bad boys. Chad

Have these sold yet?

Sorry I have been so busy I haven't had a chance to thank you all for your input. I do appreciate it. I'm taking a look at all the different recommendations now. Chad

It has the Sledge 1000 amp

If you had a choice between one SVS PB13 Ultra Sub or 2 Klipsch SW-115 subs, which would you go with?

Thanks everyone for the input, I think I will go a cheaper route based on your input. Chad

I've been searching bi-wire speaker cable for my front RF-82 II and my RC-64 II, and single wire for my, 2 (soon to be 4) RS-64 II. I consider the room to be medium size at 18'x18'. So I'm going to need 2-8' bi wire for the front speakers and 1-2 to 3' bi wire for the center channel. 2-24' single for the side speakers and 2-29' for the rears, these measurements are including running up over and through the walls. Those lengths get expensive!! I've priced it out at $1000.00 if I go with Anti-Cable, and was wondering if anyone has any used this brand with a Klipsch surround sound system or even better one simular to mine? Thanks in advance for any input or direction you can offer me, it's greatly appreciated. Chad

*hire

Just wanted to give Todd some props. I received the RC-64 II from him the other day. It arrived the next day, and it looks great!! The packaging was the best I've ever seen. You couldn't even buy them from Klipsch packaged as well as this was. Thanks for Everything Todd I appreciate you taking great care in getting my new baby to me. lol BTW, Klipsch if you're looking for someone to insure your shipments arrive without any damage I strongly recommend you this guy!!! lol

Happy to see it didn't take to long for my friend Michael to get a big head!!! lol

Not that I have ANY interest in these speakers, but Nashville just seems way to far to drive!!! Lmao

I just wanted to thank you for your comment Mustang. My intent was not to get the seller in trouble. I consider Youth a new friend and understand his point. My intent wasn't to get a seller with an impeccable record in trouble, to be honest I didn't even look at the seller's track record. That being said, I could care less, no offense to Youth. I never thought they tried to mislead a potential buyer, but I thought I owed it to the e-bay community to inform the 17 bidders that they weren't going to get the item they thought they were bidding on. Maybe I went about the situation incorrectly by notifying E-bay of it first, but I did notify the seller of the fact that I reported it to e-bay, and therefore maybe denying the seller the option of amending the listing. This was the first time I've even ran across this situation and I'm learning as I go. I do appreciate friends input though so I can go about the right way to approach this situations in the future. Chad

CONGRATS!!!!! It's always great to hear a transaction going better then even you could have EVER expected!!! E N J O Y!!! PS. I don't even know you . but I hate you already!!! ahhhhh, JEALOUSY!!! lmao J/K

Another thing is this listing already had 17 bids, and a no return policy. Just trying to help people out rather then them being disappointed later is all.

I understand accidents happen, I wasn't trying to get the seller in trouble, but it seemed odd that the large description seemed to be typed by hand and not copied from lets the the Klipsch website. So how could you hand type a large description regarding the speaker and continually referencing the wrong model number yet you put the right one in the box above as the right model model number and yet still using the listing heading as a RC-62. Just seemed weird to me, and maybe I jumped the gun because I recently purchases an RC-35 which also listed as a RC-62 II. My bad. lol

Either my report to e-bay, or the message I sent the seller, ended the sale almost immediately.

I'm not seeing this chain icon, I tried to create the link the first time, but it doesn't seem to be working for me. I'm using Chrome, btw.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=261172274946 Only in one section does this seller state that this is a RC-52 the rest of the listing gives a description of the RC-62, but if you look at the pictures the Klipsch sticker on the back clearly shows it's an RC-52. I have reported the listing to E-Bay,