achapman Posted October 20, 2009 Share Posted October 20, 2009 Easy fix? Ruins the entire sound. I press down on the back of the cabinet, towards the middle upper, it stops the sound. Dynamat or what do you think? Quote Link to comment Share on other sites More sharing options...
wuzzzer Posted October 21, 2009 Share Posted October 21, 2009 If you do a forum search you'll find several threads discussing gluing the KLF series cabinets. Unfortunately its a common problem with them. Quote Link to comment Share on other sites More sharing options...
Cal Blacksmith Posted October 21, 2009 Share Posted October 21, 2009 I just went through this with a set of KG 5.5 cabs. I went to the home improvement store and bought some 3/4 x 3/4 square strips of wood, they are in the high quality wood section and you will pay for them. I bought them so that they went full length of the inside of the cab with about 2 inches of space on either end, in my case, they were 30" long. I took the drivers out of the cabs so I could reach the inside. I cleaned up all of the glue that was smeared around the joint and got the wood ready for glueing. I made some clamp sticks, sticks that are just slightly longer than the distance between the new corner glue blocks and the distance between the motor board and the top of the glue blocks. When wedged, they should apply pressure to hold the glue blocks in place but should not put a large pressure on them so that you don't bow out the cabs or back. I used Gorilla glue as per the instructions (white, quick setting) and within 2 hours we were gently playing music and the next day, we cranked them up pretty darn good. No rattle to be found. I did both cabs as if one is going, the other will likely be close also. The whole fix, wood for glue blocks, wood for glue clamps and the glue cost about $24 total, add an hour per cab and you are back in music. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.