D. Ryan Posted June 27, 2011 Share Posted June 27, 2011 Was just wondering if the 807 has the capablity to bridge 2 amp sections to one speaker i tried to google and couldn't find much on the topic. i dont think i will need to but would still like to know if its an option or not Quote Link to comment Share on other sites More sharing options...
JasonJCarney Posted June 27, 2011 Share Posted June 27, 2011 It will say in the owners manual wether or nit you can bi-amp the fronts. Quote Link to comment Share on other sites More sharing options...
StephenM Posted June 27, 2011 Share Posted June 27, 2011 I know my 707 can biamp the front speakers so I would presume the 807 can. However, it is my experience that biamping via a single receiver yields little in the way of results. Quote Link to comment Share on other sites More sharing options...
cornfedksboy Posted June 27, 2011 Share Posted June 27, 2011 My 708 allows for bi-amping of the two front speakers. You bi-amp with the front high or front wide, but you then can not use a traditional 7.1 system (only 5.1). I'll agree with the above that you will likely not get better sound by bi-amping as you end up taxing your receiver more than anything. Quote Link to comment Share on other sites More sharing options...
SuBXeRo Posted June 27, 2011 Share Posted June 27, 2011 biamping for the sake of sound quality is one thing but if you are biamping for additional power, that is a good thing, especially from a receiver since they are in most cases underpowered with all channels driven. It helps in the low end to have that extra power. I dont know what you HT consists of but it may or may not be benefical. Quote Link to comment Share on other sites More sharing options...
D. Ryan Posted June 28, 2011 Author Share Posted June 28, 2011 System build in Sig now... Onkyo here on friday wanted to bridge two channels of it to the KG4s Quote Link to comment Share on other sites More sharing options...
StephenM Posted June 28, 2011 Share Posted June 28, 2011 Just read up on the biamping option. You can route two sets of speaker wire to each speaker using the mains terminals as well as a set of rear channel terminals. In my 707 it's under the basic speaker setup section. I don't believe there is an actual bridging option though. Quote Link to comment Share on other sites More sharing options...
D. Ryan Posted June 28, 2011 Author Share Posted June 28, 2011 Bi amping requires compatible speakers i belive... ill look when it gets here Quote Link to comment Share on other sites More sharing options...
StephenM Posted June 28, 2011 Share Posted June 28, 2011 Ahh I see your speakers don't have the two pairs of inputs. Nevermind then. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.