CANT Posted May 30, 2013 Share Posted May 30, 2013 Does anyone have these by any chance??? Thank you for your time, Quote Link to comment Share on other sites More sharing options...
philly0116 Posted May 31, 2013 Share Posted May 31, 2013 Ive got a pair of oak 1.2's Quote Link to comment Share on other sites More sharing options...
philly0116 Posted May 31, 2013 Share Posted May 31, 2013 Lol. Sorry, my slow brain just realized you want the schematic!! Quote Link to comment Share on other sites More sharing options...
CANT Posted June 3, 2013 Author Share Posted June 3, 2013 I finally broke down and bought a meter to measure inductors so I should have what I need now... Thanks Quote Link to comment Share on other sites More sharing options...
CANT Posted June 7, 2013 Author Share Posted June 7, 2013 In case any one else needs it.... I know the KG1.2 is basically the same but I need to crack them back open to meter the inductors just to make sure. Quote Link to comment Share on other sites More sharing options...
CANT Posted June 16, 2013 Author Share Posted June 16, 2013 Here is an update for the KG2.2... after metering a few known inductor values in and out of network I found I had to allow for a higher in network variance. I should also mention that I previously upgraded the resistor and both capacitors in the tweeter circuit so what is listed is the replacement value. The original values were 1ohm, 4uf and 8uf I believe? Quote Link to comment Share on other sites More sharing options...
CANT Posted June 16, 2013 Author Share Posted June 16, 2013 ...and here is the KG1.2 Again, I have replace the resistor and both caps in the tweeter circuit. I believe the original values were 5ohm, 5uf and 8uf. Quote Link to comment Share on other sites More sharing options...
Sepen Posted June 26, 2013 Share Posted June 26, 2013 sent a PM instead Quote Link to comment Share on other sites More sharing options...
moray james Posted June 27, 2013 Share Posted June 27, 2013 When you used your meter to measure the inductors did you measure them in the circuit or did you lift one leg of the inductor under test? Best regards Moray James. Quote Link to comment Share on other sites More sharing options...
CANT Posted July 5, 2013 Author Share Posted July 5, 2013 No, I did not desolder any of the inductors measured... all of the measurements list are in network measurements that have been adjust to reflect a -10% variance I noted measuring KG4 inductors in and out of network as a baseline. Removing the inductors or lifting one leg would have been the more precise to take the measurements but I didn't want to damage the inductors since I was not replacing them at this time. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.