tct Posted January 3, 2018 Share Posted January 3, 2018 Hey, I got the following setup and am looking to tune settings from AccuEQ Room Calibration RF-62II for front left and right RC-52II Center R-12SW Onkyo TX-RZ720 receiver Speaker impedance from the receiver settings is currently set to 6 ohms. The only other option is 4 ohms. The receiver crossover is set to: 40Hz for the front, 90Hz for the Center and 120Hz for LPF of LFE. Quote Link to comment Share on other sites More sharing options...
wuzzzer Posted January 3, 2018 Share Posted January 3, 2018 Ohms at 6. All crossover points at 80Hz. Quote Link to comment Share on other sites More sharing options...
willland Posted January 3, 2018 Share Posted January 3, 2018 tct, Welcome to the forum. 4 hours ago, wuzzzer said: Ohms at 6. All crossover points at 80Hz. Great starting point. And ending point most of the time. Bill Quote Link to comment Share on other sites More sharing options...
tct Posted January 4, 2018 Author Share Posted January 4, 2018 Thanks! I'll set it to that and run the AccuEQ Room Calibration afterwards. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.