MicroMara Posted January 16, 2020 Share Posted January 16, 2020 This is just the prototype. Unfortunately, I have to completely rebuild the housings because they are too small. I fear magnetic induction because the wax coils are all too close together. Freehand silver wire soldering is also becoming too complicated. So I have to go back there and rebuild the two housings first. Unfortunately ..... Keep you updated ........, but this will need some days ......hope you´re patient Regards MicroMara Quote Link to comment Share on other sites More sharing options...
pzannucci Posted January 16, 2020 Share Posted January 16, 2020 30 minutes ago, MicroMara said: I fear magnetic induction because the wax coils are all too close together. Freehand silver wire soldering is also becoming too complicated. So I have to go back there and rebuild the two housings first. Unfortunately ..... Regards MicroMara Why are none of the coils mounted on their sides to avoid the mutual inductance? They will definitely interfere with each other as close as they are unless one is perpendicular. 1 Quote Link to comment Share on other sites More sharing options...
MicroMara Posted January 16, 2020 Author Share Posted January 16, 2020 That was just a test setup, of course all coils are screwed to the housing with polyamide screws and nuts, and all other components will also be securely attached Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.