Ruler-Flat Heresy Midrange And Treble?

[Antone]

🙂 1/3 octave RTA of pink noise: Measured at ear level at listening position approximately 9 ft from motor board: Dayton UMM6 Calibrated measurement mic with REW software: Following this schematic: 3” by 3” reflex port

Edited October 7, 2022 by Antone
Moved to Appropriate Subforum

[moray james]

the measurements in this review were made with a state of the art klipple non acoustic measurement system, I thought that if you had not seen them already that they would prove enlightening.  

 

[wuzzzer]

6 hours ago, Antone said:

🙂 1/3 octave RTA of pink noise: Measured at ear level at listening position approximately 9 ft from motor board: Dayton UMM6 Calibrated measurement mic with REW software: Following this schematic: 3” by 3” reflex port

Did you not see the sticky in this section in giant capital letters that says “PLEASE READ BEFORE POSTING HERE” ??

[moray james]

10 hours ago, wuzzzer said:

Did you not see the sticky in this section in giant capital letters that says “PLEASE READ BEFORE POSTING HERE” ??

no I did not, can you remove my post? my apologies.

[wuzzzer]

2 hours ago, moray james said:

no I did not, can you remove my post? my apologies.

I was speaking to the OP.  For some reason people post random stuff in this section when it’s pretty obvious what this section is for.