ygmn Posted December 8, 2023 Share Posted December 8, 2023 I am re-arranging my Home Theater equipment due to new TV. I have been getting by with my RC- just sitting flat on the stereo shelves under old TV Well the new TV moves the RC-7 lower so I need to Tilt it up. I cannot find the Tilt screw! Look on Klipsch web pages and I cannot find where they sells parts like this. (It has been a while since I have visited) Does anyone know where I can purchase this screw with the glob of rubber on the end? OR What is the thread size? Metric or SAE? and I will make my own. THANKS! 1 Quote Link to comment Share on other sites More sharing options...
billybob Posted December 8, 2023 Share Posted December 8, 2023 Welcome back...! @ygmn Quote Link to comment Share on other sites More sharing options...
Ceptorman Posted December 8, 2023 Share Posted December 8, 2023 It should have a disc that the screw sits into, to keep the surface from scratching. I'll bet Parts Express sells them. Quote Link to comment Share on other sites More sharing options...
ygmn Posted December 13, 2023 Author Share Posted December 13, 2023 Well I always thought the RC-7 had two sets of tapped holes - FRont and rer so you could tilt up or down. DAYUM only the rear... So no need for screw now a sI need to tilt up. But I figured it out . Little short rubber bumpers in rear - came from Cabinet drawers supply as it keeps them from slamming and less then 1/8" thick. Then my trial I stacked washers under the front with a furniture pad thingy - 1.5" tall roughly. WOrks fine - Ugly but works. So off I went to AMAZON to hunt down something to hold up the front and look like it was meant to be there. I found the below fancy door stop in the jungles of AMAZON. I will cut, sand, shave the thick rubber part to the angle I Want the speaker to be at based on height of this thing. Sticky tape it to furniture and then set speaker down on it to have it tilt up. 2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.