klipsch kid Posted March 21, 2005 Share Posted March 21, 2005 Hi again. you have all been a load of information and I appreciate it. I now have to call on you one more time. my new old klipsch belle have allot of dust on the AA crossovers. is there a easy and safe way to clean them? should I use one of those air in a can things or just take them off and turn them upside down and shake them? thanks again. klipsch kid. Quote Link to comment Share on other sites More sharing options...
BEC Posted March 21, 2005 Share Posted March 21, 2005 Well, the way we do it when doing a rebuild is to remove all the components and then clean the board up. Everything is on there with screws so no unsoldering would be required to do that. Bob Crites Quote Link to comment Share on other sites More sharing options...
Deang Posted March 21, 2005 Share Posted March 21, 2005 Sandblaster. Quote Link to comment Share on other sites More sharing options...
greg928gts Posted March 21, 2005 Share Posted March 21, 2005 If you have an air compressor, you might try this. It works good for me. After removing them from the speakers, I spray them down with glass cleaner and then blow them off with compressed air and use a rag to wipe down the wires and components as I use the air to get all the cleaner out from behind and underneath the components. It's quick and does a pretty nice job of cleaning everything up. Greg Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.