jwc Posted December 14, 2013 Share Posted December 14, 2013 Probably a dumb question.....anyone have the PDF on this? 1 1/2 or 1 3/8? Quote Link to comment Share on other sites More sharing options...
Pete H Posted December 14, 2013 Share Posted December 14, 2013 I can check the bars when I get home but don't have a PDF Quote Link to comment Share on other sites More sharing options...
jwc Posted December 14, 2013 Author Share Posted December 14, 2013 I bought the 1 1/2.....but it seems I would have to tap with a hammer to get in there. I'm embarrassed but.....I never used the poles on any of my past setups Quote Link to comment Share on other sites More sharing options...
Pete H Posted December 14, 2013 Share Posted December 14, 2013 I don't have to tap them to get them in. Quote Link to comment Share on other sites More sharing options...
Pete H Posted December 18, 2013 Share Posted December 18, 2013 Really measures about 1 7/16 so 3/8 is probably going to be a bit sloppy so better a little tight. Quote Link to comment Share on other sites More sharing options...
djk Posted December 18, 2013 Share Posted December 18, 2013 Use 1-3/8", the amount of slop is only ±1/32", a 1-1/2" pole will not fit properly. You could wrap the 1-3/8" pole with a layer of duct tape if you want it too tight. Quote Link to comment Share on other sites More sharing options...
jwc Posted December 22, 2013 Author Share Posted December 22, 2013 Thx. I screwed up and got the wrong size Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.