2 channel amplifier ?

[Youthman]

The manual of your Monoprice Tube Amp doesn't state anything about being able to bridge it so I'm guessing it's not designed to do so. 

 

https://www.monoprice.com/product?p_id=13194

 

I personally would not try it with your amp.

[zackolesouth]

Ok thank you everyone


Sent from my iPhone using Tapatalk

[Youthman]

1 minute ago, wvu80 said:

The only way you can bridge your amp is if your manual specifically tells you that you can and gives you instructions on how to do that.

Exactly.

[USNRET]

and 25 watts into a Heresy would be quite enough; I have used 6

[Youthman]

Just curious what is the main reason you want to bridge the amp?  Typically bridging an amp increases distortion significantly.  I would think you would want to have as clean of a signal going to the speakers as possible.

[The History Kid]

1 hour ago, zackolesouth said:

rca to aux

Someone might correct me if I'm wrong, but generally this is not advised onto a power amp.  You'll want to make sure that whatever device you're using has a volume toggle, and if I'm not mistaken how the conductors are lined up on the ends of the 3.5 mm jack tends to add noise into the line.  That last bit, I'm not 100% on, but you'll want to use a bit of caution with that.  It's designed to receive a signal from a preamp, not a phone.