CECAA850 Posted June 6, 2014 Share Posted June 6, 2014 To me this reads like you can connect only one speaker That's what you said you wanted to do, hook it to a sub. Quote Link to comment Share on other sites More sharing options...
whatever55 Posted June 6, 2014 Share Posted June 6, 2014 The mono output signal is identical at Outputs A and B, So you can connect one speaker to A and another to B and the amplifier responds to a single combined speaker load. To me this reads like you can connect only one speaker Yes but the first statement says "The mono output signal is identical at Outputs A and B,"Are they 2 seperate outputs or just one. Quote Link to comment Share on other sites More sharing options...
derrickdj1 Posted June 6, 2014 Share Posted June 6, 2014 (edited) The amp has two channels, A and B but, I only use channel A in bridge mode. You can do it either way but, the best was is to only use channel A. Make sure the Neutrik connector is configured for bridge mode. There is a pic of the correct Neutrik connection on the back of the amp. Use the positive to +1 and the negative of the speaker wire to +2. This was important for me since I wanted the full 3000 watts for the I Nuke 3000 which was running two sub. Just use the limiter under tab # 1 in the GUI menu. Edited June 6, 2014 by derrickdj1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.