Chris A Posted December 2, 2010 Share Posted December 2, 2010 How would you go about building SPUDS behind the Khorns (assume you mean Klipschorns), which I'm using as my mains? Actually, that comment was meant to imply that the SPUDs could simply be placed in the corners and the Klipschorns (Khorns) placed up against the SPUDs along the front wall.The advantage of this arrangement is that the SPUDs and Khorns mutually benefit: 1) The Khorns benefit in being moved slightly out of their corner into the room in order to have "clear air" between the left and right speakers for superb imaging performance. The SPUDs act as one half of a false corner to close the gap between the Khorn and the front wall, and the SPUD cabinet very rigid (a good thing for the Khorn bass performance). 2) SPUD performance is significantly increased by being placed in the corner with the mouth of the SPUD next to the floor and the side walls - fully in the corner. The space between the Khorn and the SPUD forms a partial extension to the SPUD's horn length and gives you flat bass performance to a very low frequency (~17-18 Hz depending on the stiffness of the outside walls). What is used as a source, is the signal to the Klipschorns split? It's easiest to use a HT AV processor to provide a subwoofer output signal to the SPUDs (simply split the AVP's sub out signal to two or four amplifier channels - to power the two SPUDs). I find that this works also for 2-channel operation, but audiophile purists that want to use separate preamps for HT at two-channel operation could simply use an active crossover like a EV Dx38, DC-One, or other unit downstream of their preamps to provide full-time SPUD performance.It really makes a difference in both HT and two-channel operation with the Jubs in my room (see profile). Chris Quote Link to comment Share on other sites More sharing options...
Coytee Posted December 3, 2010 Share Posted December 3, 2010 By 6.1 I'm guessng you're talking about using two La Scalas as center forward/rear with a sub? Do they even make a place for a rear center? (I'm talking about in the electronics) I'd suggest just keep it simple. Put together a 5.1 (or a 5.9 if you want a lot of subs [6]) and perhaps keep the extra LaScala for future 7.x use or use it as an outdoor movie night speaker, garage speaker or.... maybe let the wife put her plants on THAT speaker instead of the others! (so they don't get ruined). Or you could sell it Quote Link to comment Share on other sites More sharing options...
tragusa3 Posted December 3, 2010 Share Posted December 3, 2010 My processor does allow for you to configure with 2 rear surrounds or 1 rear surround (6.1). It becomes more of a benefit the longer your room is. Quote Link to comment Share on other sites More sharing options...
shelbygt Posted December 3, 2010 Author Share Posted December 3, 2010 Lots of great information. My amplifier is pretty versatile. I could go 6.1 I think. Will have to break out the manual. I didn't realize the La Scala was effective against a wall as well as in a corner. That's good to know. I'll do a center front rear as my room is kind of long at 26' and in the meantime I'll search for another La Scala to go 7.1. You find these things in crazy places. One pair I have came out of a church of all places. I'm going to check into SPUDS. I'm handy enough and poor enough to try anything! Sounds like folks here are happy with them. I could make a pair out of oak to match my Klipschorns and tuck them behind them. Anyone out there have SPUD plans? Quote Link to comment Share on other sites More sharing options...
sunburnwilly Posted December 4, 2010 Share Posted December 4, 2010 Here's your center better hurry ! http://community.klipsch.com/forums/t/142150.aspx Quote Link to comment Share on other sites More sharing options...
shelbygt Posted December 4, 2010 Author Share Posted December 4, 2010 Looks like you could buy a new La Scala 2 direct from Klipsch for $500 less. I'd go with a new one before spending $3500. Quote Link to comment Share on other sites More sharing options...
tragusa3 Posted December 4, 2010 Share Posted December 4, 2010 His price is $350. It's hard to read with the OBO behind it. Quote Link to comment Share on other sites More sharing options...
Moderators dtel Posted December 4, 2010 Moderators Share Posted December 4, 2010 Do they even make a place for a rear center? (I'm talking about in the electronics) I don't think they do anymore, but they did a few years ago, my Yamaha RX-V730 has a rear center channel and says 6.1. It's about 5 years old, still works fine but one button on the remote is VERY slow, the one to lower the volume, which is a pain. Quote Link to comment Share on other sites More sharing options...
tragusa3 Posted December 4, 2010 Share Posted December 4, 2010 Maybe I'm misunderstanding the question? Again, my processor does, and it's a brand new model. Quote Link to comment Share on other sites More sharing options...
shelbygt Posted December 4, 2010 Author Share Posted December 4, 2010 Okay I see that now. I'm up in Iowa, quite a ways away from Texas. I'd sure be interested if it was closer. Quote Link to comment Share on other sites More sharing options...
shelbygt Posted December 4, 2010 Author Share Posted December 4, 2010 Okay, I see that now. I'm up in Iowa, which is a ways away from San Antonio, TX. I'd sure be interested otherwise. Quote Link to comment Share on other sites More sharing options...
Chris Robinson Posted January 2, 2011 Share Posted January 2, 2011 Late to this thread ... I have a pair of modified Klipschorns (ALK Universals plus V-Tracs) and a center Belle with Heresy surrounds. The Belle makes a very nice center, especially since it is shallow in depth and fits into 20" deep millwork very nicely. The front array integrates very seamlessly and is amazing with excellent source material. I have a Danley DTS-20 also buried in millwork since the footprint (standing on end) is so small. The DTS-10 (two) looks like a killer setup although I have a hard time comprehending how much "thunder" those things must put out. The DTS-20,aka the Tower of Power, has half the power of a single DTS-10, and the presence of the TOP is scary. It literally loosens my bowels on occasion (probably too much information, but it's true). Old School Heritage makes for wonderful home theater, just ask Indy or anybody else who's done it. The best of the best, in my opinion! Chris Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.