slipknott Posted December 12, 2021 Share Posted December 12, 2021 hello. im new to the forum however have looked at it for years. im installing new diaphragms in a pair of quartets and i cant seem to find a schematic. one speaker had the green (+) to the - on the tweeter and the other was green to +. i believe from what i can find the tweeter is to be wired out of phase. can any one verify this? thank you, Quote Link to comment Share on other sites More sharing options...
jjptkd Posted December 12, 2021 Share Posted December 12, 2021 2 hours ago, slipknott said: hello. im new to the forum however have looked at it for years. im installing new diaphragms in a pair of quartets and i cant seem to find a schematic. one speaker had the green (+) to the - on the tweeter and the other was green to +. i believe from what i can find the tweeter is to be wired out of phase. can any one verify this? thank you, Green is positive black is negative if they are wired out of phase that would be done at the crossover and not the external wiring. 1 1 Quote Link to comment Share on other sites More sharing options...
slipknott Posted December 13, 2021 Author Share Posted December 13, 2021 thank you for the reply! looks like im taking them back out. just seemed odd to me the wiring diagrams i could find were for heresy ii which i also own and thats what i was going on.. Quote Link to comment Share on other sites More sharing options...
ricktate Posted December 13, 2021 Share Posted December 13, 2021 Looks like t is... Quote Link to comment Share on other sites More sharing options...
ricktate Posted December 13, 2021 Share Posted December 13, 2021 Negative is to plus on tweeter. Quote Link to comment Share on other sites More sharing options...
ricktate Posted December 13, 2021 Share Posted December 13, 2021 Quote Link to comment Share on other sites More sharing options...
jjptkd Posted December 13, 2021 Share Posted December 13, 2021 2 hours ago, ricktate said: Negative is to plus on tweeter. This is already done inside the crossover so the green wire is correct for the positive terminal. Quote Link to comment Share on other sites More sharing options...
Dave A Posted December 13, 2021 Share Posted December 13, 2021 If you look closely at the plastic where the spade end connections are on your diaphragm you will see a + mark on one of the terminals on the top side. As stated black is to negative and the colored wire to the positive. 99% of the time the wires are crossed at the driver and not the crossover. Both deserve checking though Quote Link to comment Share on other sites More sharing options...
Alexander Posted December 13, 2021 Share Posted December 13, 2021 If you were to look at the xover PCB trace side you would find the green wire is attached to the same negative/ black wire trace going to the mid range driver. Which in-turn leads to the negative binding post on the cup. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.