Vinyl - Record Spinning

[JohnJ]

That KWSB is a good release Mike!!

[dirtmudd]

31 minutes ago, JohnJ said:

That KWSB is a good release Mike!!

 

 

Been waiting for it to be re-release.  I forgot about 6 months ago so I pulled the trigger yesterday. 

[dirtmudd]

Record fair next sunday..

 

Not sure what I'm looking for some Alan Holdsworth Nina Simone.. all I could come up with so far

[dirtmudd]

I remember now 

 

 

 

 

 

 

 

[JohnJ]

Capezios, Schnapps, parachute pants, peer pressure and that Mopar big-block! 

[Tim Sr.]

1 hour ago, JohnJ said:

Capezios, Schnapps, parachute pants, peer pressure and that Mopar big-block! 

..... Pontiac!

[JohnJ]

17 minutes ago, Tim Sr. said:

..... Pontiac!

Hmmm, was it a GOAT or another? Mine wasn't a 440 but their 400 in`73 wasn't a slouch

[Tim Sr.]

17 minutes ago, JohnJ said:

Hmmm, was it a GOAT or another? Mine wasn't a 440 but their 400 in`73 wasn't a slouch

yeah the Olds 442 was always a challenge

Today it's different, way too much engineering to tone things down, ... makes sense to make it bigger and more powerful just to restrict it.

[Klipsch104db]

Whatever happened to Robert Gordon?

[Klipsch104db]

Always take care while dusting 😬

[JohnJ]

I hope that isn't your Audio Technica cart!

[Klipsch104db]

4 minutes ago, JohnJ said:

I hope that isn't your Audio Technica cart!

No, only a friendly public service announcement.

[JohnJ]

Sad Cantilever

[Tim Sr.]

That could be fixed very gently and a pair of 12" Vice Grips!

[JohnJ]

2 minutes ago, Tim Sr. said:

That could be fixed very gently and a pair of 12" Vice Grips!

Not with my boron !!

[Tim Sr.]

Gentle as in a small whack with a 5 Lb hammer @JohnJ

[JohnJ]

1 minute ago, Tim Sr. said:

Gentle as in a small whack with a 5 Lb hammer @JohnJ

only if it's been properly rejected & replaced!

[Tim Sr.]

You have to apply heat with Boron, Propane torch is adequate

[JohnJ]

3 minutes ago, Tim Sr. said:

You have to apply heat with Boron, Propane torch is adequate

My Precioussss

Not with my....

 

https://www.audio-technica.com/en-eu/cartridges/line-series/at33-series/at33ptg-ii

[Tim Sr.]

There is the possibility of a 1 mm ID Stainless steel pipe slid over the cantilever, and use it as a pry bar, work it back n forth a few times (20-30) straighten that puppy right up!!