Pete H Posted January 5, 2021 Share Posted January 5, 2021 I too, have the same jig and the center comes out. Engineers Quote Link to comment Share on other sites More sharing options...
Seadoc Posted January 13, 2021 Share Posted January 13, 2021 rplace: Should be pretty straight forward if you have not already done so. The Jasper Circle jig will work fine and skip using the Spiral bit. Sequence I would do. 1) Set up the Jasper -> pin your circle guide to 15.375". On the backside (orange below). 2) Still pinned do your cut passes (Lime below) until you reach .6875" (Purple below). Also on the backside. 3) Drill you mounting holes, if applicable. From the front side. 4) Cut your 14" thru hole. From the front side. 5) Clean-up 6) Have a beer. 1 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.