Stube-id Posted April 4, 2023 Share Posted April 4, 2023 Pros, cons and preference of LaScala AL5s with and without DSP? Quote Link to comment Share on other sites More sharing options...
Moderators Travis In Austin Posted April 4, 2023 Moderators Share Posted April 4, 2023 Welcome to the Forum! Quote Link to comment Share on other sites More sharing options...
DirtyErnie Posted April 4, 2023 Share Posted April 4, 2023 With? Con: More Gear. Pro: can tune the system and the room to something resembling 'perfection'. Without: The opposite of that ^^^^^^^^^. 2 Quote Link to comment Share on other sites More sharing options...
JMeader Posted April 4, 2023 Share Posted April 4, 2023 First spend the time to locate your speakers in your room. given the weight of La Scalals a couple of $15.00 roller dollies will really help https://www.harborfreight.com/18-in-x-12-in-1000-lb-capacity-hardwood-dolly-58312.html also a simple electronic measure helps. Simple way to measure distances to back and side walls as well as you listening position. In addition you would be surprised that when you tilt you speakers how far off your eyes will get you. https://www.amazon.com/Bosch-GLM-20-Compact-Distance/dp/B01CG97GR2/ref=sr_1_3?keywords=electronic+measuring+devices&qid=1680620853&sr=8-3 Also some blue masking tape will allow you mark and try different locations. Also due to room differences your toe in may or may not be equal One your speakers are located, then the impact of DSP will be enhanced Hope this helps Enjoy The Music Quote Link to comment Share on other sites More sharing options...
Bubo Posted April 4, 2023 Share Posted April 4, 2023 On 4/4/2023 at 4:32 AM, Stube-id said: Pros, cons and preference of LaScala AL5s with and without DSP? Set them up with and AVR (THX rated preferred) Do the set up with the microphone on stereo Then use the direct button to toggle back and forth. 1 Quote Link to comment Share on other sites More sharing options...
jwc Posted April 6, 2023 Share Posted April 6, 2023 What is your DSP source? I would EQ the low end a little with a boost shelf around 60hz then put a high pass -48dB at 40hz. Try with and without roomeq after that if available. Ive had poor experience with AVR room EQ on several units Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.