Jump to content
The Klipsch Audio Community
Sign in to follow this  
boricua2480

Jubilee/MWM Crossover inquiry

Recommended Posts

If I had the K-402/K-1133, 510/K-69A combo that included the xover for the full jubilee setup, would that network also work if I traded out the KHJ bass bins for MWM’s? Help me out! Thanks!

Share this post


Link to post
Share on other sites
2 minutes ago, mark1101 said:

What "included" crossover are you talking about?

Either the factory 3 way crossover or the Crites built crossover designed for the 3-way version of the Jubilee. 

Share this post


Link to post
Share on other sites

MWM and jubilee bass bins are very different. It might "work" but it wouldn't sound as good as it should and might sound very bad.

  • Like 1

Share this post


Link to post
Share on other sites

Is that the same passive that JC said was designed to go behind a screen, therefore would be a little "hot" on the top end??

 

 

Share this post


Link to post
Share on other sites

I’d imagine it’s the same passive unless it’s a Crites built one that is padded down a few db’s on the top end. I just wondered if the crossover settings are the same or close between the 2 configurations of Bass bins. If not the same or close then I’d have to go back to the original idea of an active network and sell the passive crossovers. Just trying to save money if possible but if it means saving money only to have a half assed setup then that’s not the direction I’d be going. Thanks again guys

Share this post


Link to post
Share on other sites
8 minutes ago, boricua2480 said:

I’d imagine it’s the same passive unless it’s a Crites built one that is padded down a few db’s on the top end. I just wondered if the crossover settings are the same or close between the 2 configurations of Bass bins. If not the same or close then I’d have to go back to the original idea of an active network and sell the passive crossovers. Just trying to save money if possible but if it means saving money only to have a half assed setup then that’s not the direction I’d be going. Thanks again guys

You could always use a cheap mini DSP on the bottom MWM if the passive didn't work. As long as the passive top end works, no reason to sell it. 2/3 of your speaker is fine, you only need to solve a bass bin problem IF there is one in your room.

Share this post


Link to post
Share on other sites
On 7/20/2018 at 3:39 PM, boricua2480 said:

Either the factory 3 way crossover or the Crites built crossover designed for the 3-way version of the Jubilee. 

Did Crites build a passive crossover for the three-way version of the Jubilees? I have not seen it listed on the website.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

×
×
  • Create New...