Rdmarsiii Posted November 14, 2004 Share Posted November 14, 2004 How do you take the risers off of a Heresy? Thanks, David Quote Link to comment Share on other sites More sharing options...
ricktate Posted November 14, 2004 Share Posted November 14, 2004 They are just screwed on....unscrew them...Rick Quote Link to comment Share on other sites More sharing options...
Deang Posted November 14, 2004 Share Posted November 14, 2004 lol Quote Link to comment Share on other sites More sharing options...
scott0527 Posted November 14, 2004 Share Posted November 14, 2004 Hammer and chisel? Quote Link to comment Share on other sites More sharing options...
garymd Posted November 14, 2004 Share Posted November 14, 2004 I was going to recommend a chainsaw but decided it was in bad taste. Quote Link to comment Share on other sites More sharing options...
scott0527 Posted November 14, 2004 Share Posted November 14, 2004 ---------------- On 11/14/2004 10:49:05 PM garymd wrote: I was going to recommend a chainsaw but decided it was in bad taste. ---------------- Oh yea, Chainsaw, much better. Why waste time with a hammer?! Quote Link to comment Share on other sites More sharing options...
nicholtl Posted November 15, 2004 Share Posted November 15, 2004 Nothing a little lube can't handle. Quote Link to comment Share on other sites More sharing options...
Rdmarsiii Posted November 15, 2004 Author Share Posted November 15, 2004 Mine dont have screws... Quote Link to comment Share on other sites More sharing options...
fini Posted November 15, 2004 Share Posted November 15, 2004 Heresys, or Heresy IIs? Could they be screwed from inside the box? Guessing here... Quote Link to comment Share on other sites More sharing options...
Rdmarsiii Posted November 15, 2004 Author Share Posted November 15, 2004 They're Heresy Is. I dont want to do anything to hurt the finish on them (since they look like they were just made) Quote Link to comment Share on other sites More sharing options...
dodger Posted November 15, 2004 Share Posted November 15, 2004 Yours are glued on. Take the finest pry bar - very flat - and a hair dryer. Only aim the hair dryer where the riser and Speaker meet. Start warmint the area and very slowly pry the riser off. Don't get the heat too near your grille clothes as they will melt. It's a slow process but works. Sell the risers on eBay. Good Luck, dodger Quote Link to comment Share on other sites More sharing options...
Seadog Posted November 15, 2004 Share Posted November 15, 2004 Just curious, but why do you want to remove the risers? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.