OO1

keep the old wiring , clean up any corrosion on the Autoformers , check the zener diodes , the 245uH coil requires a brass screw .

it's an excellent amp

you're very right , clean SS power is the way to go for the long haul , no tubes to replace ever , no adjustments needed , no tune-ups , no repairs for 10-20-30 years , the perfect example , with an excellent pre-amp , Yamaha A-S-1000 or 1100 or 1200 , and yes quality matters , a cheap SS amp will not do

JEM is a klipsch parts vendor , the installation is easy , do not twist wires or leads , do not use too much solder or heat , you can use crimping tools , the capacitor lead should not be compressed or twisted .

the Conwall III in this thread are not a Heresy III , but they do share the same tweeter , mids horn , mids driver , if you're close by to Location 78414 , check em out

before and after pictures of Trade Secret

hard wood flooring would avoid allergens , carpets except Persian rugs also contain chemicals , wood remains cooler with excellent sound properties .

here are some dust caps /no lip on Ebay there are plenty of sizes available https://www.ebay.com/sch/i.html?_from=R40&_trksid=p2334524.m570.l1313&_nkw=speaker+dust+cap+no+lip&_sacat=0&LH_TitleDesc=0&_odkw=speaker+dust+cap&_osacat=0

the stains can be removed with a magic eraser , TRADE SECRET sold on amazon will remove the scratches and it will oil the veneer at the same time , the contents are coconut oil mixed with colorants , no VOC's , no chemicals ..... wipe it on to restore the natural finish , that 's it .

reach out to klipsch tech support via email , fill the form , and wait for an answer , be patient , they might be overwhelmed . phone USA . 800 554 7724 https://support.klipsch.com/hc/en-us/requests/new Here's are 2 bulletins , please read them carefully https://support.klipsch.com/hc/en-us/articles/360051127252-The-Fives-No-Sound-via-HDMI-ARC-Troubleshooting- https://support.klipsch.com/hc/en-us/articles/360043032612-The-Fives-Connecting-to-TV-through-HDMI-ARC Randy

a replacement amplifier for the KSP -400 would have to power a 15 inch subwoofer + the drivers , you could turn the powered speakers into a passive speaker with a crossover , but you would need to power the subwoofers separately .

You all deserve a raise , the ongoing work by the klipsch Engineering Dept is impressive

1500$ is ok , but you have to take into account that the crossovers will need a new klipsch capacitors kit

.....

the reality for 2023 are high energy + high interest rates + high labor costs + shortages in the supply chain + staff shortages + regular price increases for materials + high R&D costs , based on the uncertainty , the R&D costs will most likely be even higher in 2024 .

best deal in the west ,

the RP-1600SW are still a very good choice

good decision , no point in using aftermarkets when the original parts are available

most of us were raised with the same values , if you are enjoying a crime free town , it's because LE and the population cooperate

the subs designation can correlate with klipsch Heritage Vented sub 1 through 4 KHVS1 - small / klipsch Heritage vented sub no 1 KHVS2 - medium / no 2 KHVS3 - large / no 3 KHVS4 - Xlarge / no 4

SME 3009 arm , TD 124 MK 1 or MK 2

too bad , shipping rates are so high , GLWTS

I guess not

that's on account that Police agencies are hard at work

go ahead , update the FW , and make sure to contact klipsch tech support