DerekBro Posted November 28, 2017 Share Posted November 28, 2017 Hi everybody! I’m trying to determine if the R-15m bookshelf speakers (that are 50% off right now!) would be suitable rear channels for my home theater setup. My primary concern is that my receiver may not be powerful enough to drive them along with the other speakers, and that I would potentially damage my speakers. The receiver is an Onkyo TX-NR555. The specs are here: https://www.onkyousa.com/Products/model.php?m=TX-NR555&class=Receiver but I’m having trouble interpreting them when comparing them with Klipsch specs. This receiver is currently powering the RP-150m bookshelf speakers as the front left/right channels and the RP-250c center channel. I’d like to add the R-15m as the 2 back channels for a true 5.1 experience but I’m not sure if I’d be exceeding recommended wattage for this receiver. Help! I asked for advice last month about how to set up my subwoofer and the advice proved to be super helpful. Thanks in advance to any advice you can give! Quote Link to comment Share on other sites More sharing options...
The History Kid Posted November 28, 2017 Share Posted November 28, 2017 Will these be rear or side surrounds? There's shouldn't be any problems driving them. Quote Link to comment Share on other sites More sharing options...
DerekBro Posted November 28, 2017 Author Share Posted November 28, 2017 3 minutes ago, The History Kid said: Will these be rear or side surrounds? There's shouldn't be any problems driving them. Probably more side than rear just because I’m limited to where I can put them (they’ll be sitting on shelves instead of being mounted). Quote Link to comment Share on other sites More sharing options...
The History Kid Posted November 28, 2017 Share Posted November 28, 2017 You shouldn't have a problem with driving them at all. Side surrounds function better with omnipole though - where rear surrounds are better as direct firing. That's the only reason I ask. The R-14S or RP-240 (or 250S (timbre matched)) would be better in that position. Quote Link to comment Share on other sites More sharing options...
DerekBro Posted November 28, 2017 Author Share Posted November 28, 2017 In that case I may still get these but find a way to use them as rear speakers. They’ll have to be placed a little higher but it might work. Thanks! 1 Quote Link to comment Share on other sites More sharing options...
wuzzzer Posted November 28, 2017 Share Posted November 28, 2017 5.1 systems use side surrounds. 7.1 systems add rears. 1 Quote Link to comment Share on other sites More sharing options...
The History Kid Posted November 28, 2017 Share Posted November 28, 2017 Just to put it out there...they're still not timbre matched, but at least they still use the titanium tweeters instead of the aluminums the R-15M and R-14S use...I have a pair of RS-3's I am selling right now. They might work nicer in your setup unless you're looking at the RP-240/250S. Quote Link to comment Share on other sites More sharing options...
DerekBro Posted November 28, 2017 Author Share Posted November 28, 2017 Thanks guys. I think I'd need to find a way to put these on the side in order to be happy with them. That's one of the reason I've held back on the side surround channels--our living room will need to be reconfigured (again) to make it work. Man, I hadn't even heard about timbre matching--I'm reading about it now. I was wanting to jump on the R-15M's because of the price but maybe I should just hold out for a better match and that will give me time to figure out our room setup. You guys are raining on my parade! Quote Link to comment Share on other sites More sharing options...
The History Kid Posted November 28, 2017 Share Posted November 28, 2017 2 minutes ago, DerekBro said: Thanks guys. I think I'd need to find a way to put these on the side in order to be happy with them. That's one of the reason I've held back on the side surround channels--our living room will need to be reconfigured (again) to make it work. Man, I hadn't even heard about timbre matching--I'm reading about it now. I was wanting to jump on the R-15M's because of the price but maybe I should just hold out for a better match and that will give me time to figure out our room setup. You guys are raining on my parade! Haha...no worries buddy. You'll get there. I don't know what the difference in timbre is between what I have and the RP versions. They're technically from the same build quality/line, but these are the great-great-great-great-great-great grandfathers. lol Good luck in your search. Quote Link to comment Share on other sites More sharing options...
carlthess40 Posted November 28, 2017 Share Posted November 28, 2017 Well if you need a pair I have a set I’m not using and have no plans to use them. To tell the truth. They have never need powered up. I just lost the boxes. I’ll give you a good deal in them 1 Quote Link to comment Share on other sites More sharing options...
91RS Posted November 28, 2017 Share Posted November 28, 2017 The omnipole are better but, from what I was told, not always suitable depending on the room. I'm using RB-61 II's for my side surrounds. My couch is against the back wall so I have no room for rear surrounds and my side surrounds are in the rear corners of the room (at ear level) to be in the 90*-110* placement range so omnipole speakers would be bouncing sound off the rear wall in my case. Quote Link to comment Share on other sites More sharing options...
JohnA Posted November 28, 2017 Share Posted November 28, 2017 The specs given are disappointingly incomplete, so you can't really know what it will do. Still you probably will not exceed 20 watts/channel out of the 60-ish it should be able to deliver to all channels at once (80w x 2, 20-20k Hz, @.08%, into 8 ohms). No worries there. There may be better speakers for side surrounds that diffuse the rear signal. Quote Link to comment Share on other sites More sharing options...
DerekBro Posted November 28, 2017 Author Share Posted November 28, 2017 3 hours ago, JohnA said: The specs given are disappointingly incomplete, so you can't really know what it will do. Still you probably will not exceed 20 watts/channel out of the 60-ish it should be able to deliver to all channels at once (80w x 2, 20-20k Hz, @.08%, into 8 ohms). No worries there. There may be better speakers for side surrounds that diffuse the rear signal. Thank you! I'm thinking it might be better to wait until I'm ready to purchase/mount the RP-240S or the RP-140SA and use them as surround speakers. Quote Link to comment Share on other sites More sharing options...
RoboKlipsch Posted November 28, 2017 Share Posted November 28, 2017 i use a pair now as back surrounds 13ft away. imo they are surprisingly nice and i see no issues with you blowing them up i also agree with the opinions that the wide dispersion surrounds (double faced speakers) are beyond awesome. for value go r15m or rb51s for coolest best surround go rp240s or rp250s or rs52ii...they are all excellent Quote Link to comment Share on other sites More sharing options...
DerekBro Posted November 28, 2017 Author Share Posted November 28, 2017 1 hour ago, RoboKlipsch said: i use a pair now as back surrounds 13ft away. imo they are surprisingly nice and i see no issues with you blowing them up i also agree with the opinions that the wide dispersion surrounds (double faced speakers) are beyond awesome. for value go r15m or rb51s for coolest best surround go rp240s or rp250s or rs52ii...they are all excellent Do you notice any timbre problems using the RP speakers in front and the R15m speakers as surrounds, or do they match well enough in your opinion? Quote Link to comment Share on other sites More sharing options...
RoboKlipsch Posted November 29, 2017 Share Posted November 29, 2017 No problem. If used up front it might be noticeable. As surrounds no. Quote Link to comment Share on other sites More sharing options...
DerekBro Posted November 30, 2017 Author Share Posted November 30, 2017 I ended up pulling the trigger on these. I probably wouldn't be adding the back channels for a long time if I hadn't got these and they were such a great deal. Thanks for your advice and help everyone! 1 1 Quote Link to comment Share on other sites More sharing options...
bkevind Posted November 30, 2017 Share Posted November 30, 2017 Timbre matching is more important IMO for the L/C/R as most of the sound comes from there during movies. Regardless, you've come closer than me with overall timbre matching My Front L/C/R is RF-7II and RC-64II. My "side surrounds" are completely different, in-ceiling RSL's. My surround backs are completely different, SVS Ultra bookshelf speakers. Then my front and rear height are Klipsch CDT-5800II. I'm quite happy with the sound for movies, even 11 channel stereo sounds good to me when I use it. No glaring sound disparity, in fact it's not noticeable to me at all in my space. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.