OO1

you'll need a threaded K-703 horn , the KLF-30 /KLF-20 share the same mids horn

klipsch Parts have original klipsch pie badges , all ready with peel and stick 3M double sided tape

I'll be getting tickets for the NJ May 23rd show

the Chiefs were disappointing for the 1st time this season , the KC Chiefs need rest , time off , and lotsa of it .

-dont forget the H IV is a ported speaker design vs a sealed cabinet , you wanna keep it as close to stock as possible for optimal ( air-flow ) performance

49ers Eagles 42-19 , another win for Brock Purdy

no idea , que sera sera

a cleaner that's not approved by klipsch may make things worse , contact the dealer , report the issue , , dont do anything until klipsch have responded .with clear instructions .

https://www.klipsch.com/warranty-heritage-products

are you the original owner and are you still covered by the 10 years warranty ?

set the dial of the Ohmmeter to Ohms , unscrew 6 screws , slowly gently , separate the top plate from the magnet assembly , place the prongs on the leads of the diaphragm and check DCR , above 10 Ohms the diaphragms are working , no reading the diaphragms will have to be replaced

https://2d73e25b29782b6d6766-9c8af5cbfef16739445bc76457060528.ssl.cf2.rackcdn.com/a60thKhornBrochure_635042120283920000.pdf

enclosed backs on khorns allow the freedom to move the khorns out of the corners of the walls , for a toe in , you still need corners , but the speakers no longer have to be firmly in the corners at a fixed 45 degrees , but rather in closer proximity of a corner .

are you planning to enclose the backs of the Khorns

you forgot this

big money

when the OP says it's crackling ,he really means that the amp is overheating and distorting , so yes , the solution is not to crank the amp in order for the amp to run cooler

you need a more powerful amp , you risk damaging the 2nd amp just as easily as high distortion levels can damage the amplifier

1200$

sure they do , they dont call em pros for nothing , big difference vs an amateur

bad solder contacts or bad capacitors make no distinction whether on a wooden Xo or a PCB , same problem , same solution , here's a KP 2.0C PCB

that's correct for rock concerts , crews break-in woofers in 5-6 minutes...... at full power

the RC-64 1st generation woofers are compatible with the RF-63 .. .Klipsch part # 1000265 K-1205-NB