Hagar Posted July 12, 2016 Share Posted July 12, 2016 I posted this before some time ago. I just can't find it. I have a pair of La Scala's in my home theater system. I also use a Pioneer Elite SC27 receiver with MCACC. When I use MCACC to set up my system, it max's out the La Scala's to 10 and sets the rest properly. Doesn't do it with my RB35's hooked up. Anyone else have this issue. The fix is I use my radio shack sound meter to adjust all volumes manually. And before I post another issue, let me run it through a filter here. My La Scala's are vintage 1992. That's 24 years old. The general consensus is you should replace your capacitors every 15 or so years as they break down and this according to Bob Crites and other notable sources. Sounds reasonable to me. So why isn't there a sticky post that everyone should replace their caps every so often for better sound? Should I ask in the two channel sound or technical mod section? Dave Quote Link to comment Share on other sites More sharing options...
wvu80 Posted July 12, 2016 Share Posted July 12, 2016 (edited) I have a pair of La Scala's in my home theater system. I also use a Pioneer Elite SC27 receiver with MCACC. When I use MCACC to set up my system, it max's out the La Scala's to 10 and sets the rest properly. Doesn't do it with my RB35's hooked up. My Audyssey sets the speakers relative to reference level. That means at reference which is 82 on my Onk AVR the Khorns are set at -10 (maybe -12, can't remember). Anyone else have this issue. The fix is I use my radio shack sound meter to adjust all volumes manually. What volume do you set them to? At what level? If you knock down the DB's of the LS's then you've got to boost the other speakers and you may be introducing distortion into your system. My Audyssey does a better job of level matching my hodge podge of speakers than I can do. +++ My La Scala's are vintage 1992. That's 24 years old. The general consensus is you should replace your capacitors every 15 or so years as they break down and this according to Bob Crites and other notable sources. So why isn't there a sticky post that everyone should replace their caps every so often for better sound? Should I ask in the two channel sound or technical mod section? There was a sticky just introduced a few days ago in Tech Mods on "Building the AA" by Dean G. Maybe your suggestion that caps be replaced every 15 years would be a nice addition to his Page 1 post. Edited July 12, 2016 by wvu80 Quote Link to comment Share on other sites More sharing options...
Schu Posted July 12, 2016 Share Posted July 12, 2016 With my cornwalls... my system sounded better with mcacc correction, with my la scalas my system sounds MUCH BETTER with the system running flat... no correction other than manual distance settings. Quote Link to comment Share on other sites More sharing options...
Hagar Posted July 13, 2016 Author Share Posted July 13, 2016 I have a pair of La Scala's in my home theater system. I also use a Pioneer Elite SC27 receiver with MCACC. When I use MCACC to set up my system, it max's out the La Scala's to 10 and sets the rest properly. Doesn't do it with my RB35's hooked up. My Audyssey sets the speakers relative to reference level. That means at reference which is 82 on my Onk AVR the Khorns are set at -10 (maybe -12, can't remember). Anyone else have this issue. The fix is I use my radio shack sound meter to adjust all volumes manually. What volume do you set them to? At what level? If you knock down the DB's of the LS's then you've got to boost the other speakers and you may be introducing distortion into your system. My Audyssey does a better job of level matching my hodge podge of speakers than I can do. +++ My La Scala's are vintage 1992. That's 24 years old. The general consensus is you should replace your capacitors every 15 or so years as they break down and this according to Bob Crites and other notable sources. So why isn't there a sticky post that everyone should replace their caps every so often for better sound? Should I ask in the two channel sound or technical mod section? There was a sticky just introduced a few days ago in Tech Mods on "Building the AA" by Dean G. Maybe your suggestion that caps be replaced every 15 years would be a nice addition to his Page 1 post. So do you use a sound pressure meter to reference the rest to the same level? I drop my front La Scala's to -5 or -6 and then adjust the rest to the new refrence level and it all seems to work well with no overdriving. With my cornwalls... my system sounded better with mcacc correction, with my la scalas my system sounds MUCH BETTER with the system running flat... no correction other than manual distance settings. So do they MAX out? Have you replaced your caps lately. I get my back from Bob Crites this weekend. Quote Link to comment Share on other sites More sharing options...
Schu Posted July 13, 2016 Share Posted July 13, 2016 (edited) I don't need new capacitors, I have la scala II's... that being said I do have new custom crossovers coming. I don't understand the comment about maxing out... what do you mean? I run direct... no correction at all including eq, dB increases or decreases, reverb correction etc. I only tell my pre a timing setting by using fine distance settings... down to the half inch. Edited July 13, 2016 by Schu Quote Link to comment Share on other sites More sharing options...
derrickdj1 Posted July 13, 2016 Share Posted July 13, 2016 He is probably maxing out the trim level. The LaScala's are very efficient compared to the RB 35. A parametric EQ can be used to lower the level of the LaScala's and then MCACC could correctly calibrate the system. 1 Quote Link to comment Share on other sites More sharing options...
Hagar Posted July 13, 2016 Author Share Posted July 13, 2016 my Khorns did the same thing. So do you manually set the rest after reduceing the horns? I reduce my lascals to -5, and readjust the rest. And Schu, are you saying, you don't have this issue? And have you replaced your caps? Quote Link to comment Share on other sites More sharing options...
AaronB123 Posted July 16, 2016 Share Posted July 16, 2016 That's weird I have a Pioneer VSX-90 my theater is in a fairly smaller room but it sets the La Scala's to -12 which I find to seem pretty accurate especially when watching movies at reference level. Anything higher than that and I would probably go deaf. The only thing that my receiver does is it will constantly tell me my mains are out of phase when I run the MCACC. I have said this in other threads and some have laughed and thought it was a bit foolish but I heard about a trick on the AVS forum where you tape the mic to your forehead and sit exactly in your listening position and believe it or not it made a HUGE difference in the outcome of the MCACC for me as opposed to just leaving it on the headrest or even the seat of the listening position on the couch. I personally found whenever I didn't do the forehead trick the sound settings came out way too bright and tinny as opposed to the deeper much richer fuller soundstage I got when doing the mic on the forehead trick. I would say it's worth a shot you never know. Quote Link to comment Share on other sites More sharing options...
rebuy Posted July 16, 2016 Share Posted July 16, 2016 I'd like to see a Pic of you sitting there with a mic taped to your head--- Do you use Duct Tape? 1 Quote Link to comment Share on other sites More sharing options...
wvu80 Posted July 16, 2016 Share Posted July 16, 2016 (edited) So do you use a sound pressure meter to reference the rest to the same level? I drop my front La Scala's to -5 or -6 and then adjust the rest to the new reference level and it all seems to work well with no overdriving. I don't use an SPL meter at all. My 5.1 has mis-matched center and surrounds relative to my L/R Khorns with different efficiencies and Audyssey does a great job IMO of level matching them to each other. THAT BEING SAID not everybody likes Audyssey. I think those that don't like Audyssey tend to be more sophisticated in terms of their ability adjust the sound by ear to their personal preference. That main complaint I hear about Audyssey is that the sound comes out flat, an audio characteristic not everybody likes. Edited July 16, 2016 by wvu80 Quote Link to comment Share on other sites More sharing options...
Scrappydue Posted July 16, 2016 Share Posted July 16, 2016 (edited) That's weird I have a Pioneer VSX-90 my theater is in a fairly smaller room but it sets the La Scala's to -12 which I find to seem pretty accurate especially when watching movies at reference level. Anything higher than that and I would probably go deaf. The only thing that my receiver does is it will constantly tell me my mains are out of phase when I run the MCACC. I have said this in other threads and some have laughed and thought it was a bit foolish but I heard about a trick on the AVS forum where you tape the mic to your forehead and sit exactly in your listening position and believe it or not it made a HUGE difference in the outcome of the MCACC for me as opposed to just leaving it on the headrest or even the seat of the listening position on the couch. I personally found whenever I didn't do the forehead trick the sound settings came out way too bright and tinny as opposed to the deeper much richer fuller soundstage I got when doing the mic on the forehead trick. I would say it's worth a shot you never know. well that's cause sticking it on the headrest is a waste since you sit lower than the headrest on most furniture. And are you saying ou just sat it in the seat? A mic stand or tripod is best. I would think a mic taped your forehead would block sounds from the rear a tad resulting in higher spl from the rears after calibration. Edited July 16, 2016 by Scrappydue Quote Link to comment Share on other sites More sharing options...
nitrofan Posted July 16, 2016 Share Posted July 16, 2016 Wvu80 you described my experience with audyssey perfectly. It made everything flat and dull with no dynamics i hated it Quote Link to comment Share on other sites More sharing options...
nitrofan Posted July 16, 2016 Share Posted July 16, 2016 If you were watching the news i guess it would be fine but for movies, no thanks Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.