Trey Cannon

Most issues are found in the screw terminals. Loose and need cleaning...contact cleaner and a pencell erasure can do a good job. Only if the caps are leaking fluid or have leaked, would you need to change the caps. Inductors are just wire, so no worry there. Connect them to an amp and have fun. I use my 1979 LS as my center....

I think I am right there with ya....

take the grill off...4 screws on the outside edge ....turn them left until the speaker becomes lose in the ceiling...DO NOT TAKE THEM ALL THE WAY OUT!!! Once lose a little, they will turn the "dogs" out of the way and allow the speaker to come out of the ceiling. Before all that, I would use a battery to test the speaker from the back of the amp....play morris code with the speaker wire and the battery. It goes back in the ceiling the same way it came out.

If you still have questions....I may be able to help.

When doing the spec for cinema, We used them as ceiling speakers....Not an issue if you use a correct mount. I use KPT-1200M for my ATMOS tops.

I use mine in the Mill room....Has to get over the SPL of the mill....I will get a pic later.

Sorry Guys I have been MIA for some time now. From memory, There were a few P Parts hid around. Reach out to Jeremey McWilliams in customer service. He will be about the only one left there that may have a clue where they may be. There was no other speaker line that had that driver. Klipsch sold off much of the old stock parts to Simply Speakers (I think) If they have one listed, it may be a stock part. That's My 2db Good luck.

REW can only test SPL at a 2.7sec time laps...You had better be outside or in a VERY big room no to get the ROOM in the curve... This is because it is a ROOM EQ WIZARD...Not a speaker measuring tool.

1006891 AW/CA650T Tweeter w Horn OUT OF STOCK... ETA Late May / early June.

Omni mount used to make one...No idea any longer.

Looks like I jumped the gun as well. I misread and thus misunderstood what was said. Klipsch does have the K-77-F. and the diaph kit for that driver. Roy jumped the gun here...the F IV kit is not in the system and can not be ordered yet. It has a part and a price, but not ready for prim time.

Have a look at this...

What that *** hat has done is attempt to measure a speaker and he did it wrong in order to sku the curve so he could "fix it". If he may have a clue about speakers, as he is able to test, "fix" and test again in a different way to get the results he wants. I have the "golden standard" curves of every speaker he has "tested" and NONE of them test like he shows them testing. PWK handed out little yellow buttons for this....BULLSHIT!

You need to use a 4 Ohm resistor in place of the woofer to see the VT of the net... Dean is right, you have VC and filter.

The "go build your own speaker co." was something Paul said while tossing me out of his house...I just used it. THIS IS FROM THE MOUTH OF TREY CANNON....NOT KLIPSCH!