Jump to content

Any Turntable Gurus?


Tarheel
 Share

Recommended Posts

The cartridge cable in the ADC arm broke off somewhere in the tone arm shaft so I'm looking to replace the arm with a Rega/Moth, Jelco, SME, or any other decent arm.  I need someone to do the install and set it up properly.  I do have a blank arm board.

A long shot but you never know.......

Located in North Carolina and will ship.

IMG_1587.JPG

  • Like 1
Link to comment
Share on other sites

7 minutes ago, Tarheel said:

The cartridge cable in the ADC arm broke off somewhere in the tone arm shaft so I'm looking to replace the arm with a Rega/Moth, Jelco, SME, or any other decent arm.  I need someone to do the install and set it up properly.  I do have a blank arm board.

A long shot but you never know.......

Located in North Carolina and will ship.

IMG_1587.JPG

Best of luck!!

Do you know a good competent audiophile gear repair shop local to you? I'm in StL and am lucky to have Alpha Tech close here in St louis MO:

www.alphatechstl.com

and I would first consult with them about the repairs needed.

John Kuthe...
 

Link to comment
Share on other sites

3 minutes ago, rplace said:

Did you look into Britt audio? In NC I think. They did a great job on my arm rewire. Not sure if rewire is an option over new arm for you.

Yes I did.  He no longer works on turn tables but does have the Rega arm for $299.  Thanks!

Link to comment
Share on other sites

New arms should come with a template, my Jelco did. The center hole is marked and then you drill the hole for the tower where it indicates. If you buy a used arm, you may be able to find a template on Hifi engine website. Good luck.

 

  • Thanks 1
Link to comment
Share on other sites

It might be a better option to send the arm out to be rewired. There are companies who do that. You may also find that a new tonearm might fit in the same place as the old one. If I were closer I'd do it for you, but I do not recommend shipping and old turntable anywhere.

  • Thanks 1
Link to comment
Share on other sites

The cartridge cable in the ADC arm broke off somewhere in the tone arm shaft so I'm looking to replace the arm with a Rega/Moth, Jelco, SME, or any other decent arm.  I need someone to do the install and set it up properly.  I do have a blank arm board.
A long shot but you never know.......
Located in North Carolina and will ship.
IMG_1587.thumb.JPG.e4dc0b7c24f5a3abacc942cb80272947.JPG



That’s a really good arm in these tables
I’ve owned a few of them. Personally I’d rewire the arm. I done all of the denon tables that I had. I used solid silver wire and they really opened up on the sound and could really hear the difference with the left and right sound stage
The arm can be removed as a hole unit
Just need to be careful with how you do it and take your time. Good luck





Dollar for dollar Klipsch has no equals
Name one other speaker company that can build a speaker and keep working like new after 45 plus years of service. Answer NO ONE !!!!!!
  • Thanks 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...