I'm a master carpenter and former cabinetmaker. I use Titebond 1 (red cap)  or II, (blue cap) but not Titebond III and never polyurethane or epoxy.  

Will be back later, so will have to test later today. Have to figure out where the kids went with my multimeter to test the other speaker, because I forgot to bring another one with me to verify against. Honestly, I 100% expected to test virtually no resistance because I was 100% sure it had shorted.   The receiver stayed in protection mode the first time I tried restarting it, before I touched anything. After I disconnected the speaker from the wall terminals, it worked fine. I would expect if it had been any issue with the receiver, or had caused damage to the receiver at all, that it likely still would have been acting up even without that speaker hooked up.   Hopefully, the issue will have been something pressing up against the connections, and the receiver caught it quick enough to protect everything. Not holding my breath though. Fully expecting to be down a pair of speakers for awhile.   I will update when I get a chance to test.

I don’t currently have a Sonos pre amp. But I use the Sonos move and Sonos one at our office so I am familiar with there products.    Do you recommend another pre amp for the Heresy. Mine are 1979. I am trying keep using them with the modern networking- Bluetooth - Voice commands- etc. I just don’t want to sacrifice its performance to much with a smaller amp. I have a 1995 HK 60 watt 2 channel and the herersy runs great. I wast just doubtful that those newer compact amp would match up well with the vintage power??

Welcome to the forum. I just watched a video on the amp. It should work and have plenty of umph.  These small amps can work well for space constraints and WAF.  Do you have a Sonos system. There are other small amps that can power your speakers.

@What-watt   What amplifier are you asking about?   Odd that it can use EL34/6CA7 and not a KT66. KT66 is not always a direct replacement for a 6L6 because it has more filament/heater draw, but it is less than EL34/6CA7/KT77 and the KT88 only draws 0.1A more. A tube amplifier can not be optimized for multiple tube types, it a marketing thing.

Will the Sonos 2 channel amp power a pair of Heresy’s well enough?  Does anyone have experience with this or heard any play with this setup.    thanks for any advice.    Cajun Klispch fan

I have 2 klipsch groove speakers that aren’t groove xxls. Can they be daisy-chained or connected by Bluetooth to the same sound source? I’ve managed to connect both speakers to my phone but sound only comes out of one of them at any given time.

Thank you. I fixed the error this way. The problem with this line of speakers is that there is no source switching function (according to the instructions, there is, but when you open the board, the volume control button is not a multi-function button) - So the best solution is to find the switch pin. source or factory reset to connect the switch and hold down to change the power, hard reset when needed.

GONE!

I know of folks who would lay their speakers face down, on carpet, and play some bass heavy music. Might not be annoying, or when you are out running some errands. Just don't go to extremes.   They will eventually blossom.