YK Thom Posted October 7, 2015 Share Posted October 7, 2015 I have a Marantz SR 5008 HT reciever. Have had a new peice of AR furniture built to house it and other components. Using a heat gun I find that it seems to run between 105 and 120 f. I have a cooling fan unit on order which should be here anytime. How hot is too hot for this type of equipment? Quote Link to comment Share on other sites More sharing options...
CECAA850 Posted October 7, 2015 Share Posted October 7, 2015 Probably not but the cooler you keep it, the longer it will last. I have 4 pro amps and a pre-pro that loves to make heat in an enclosed cabinet. I put 2 exhaust fans on the top of the back panel and one on top of the pre-pro to exhaust heat. Everything stays barely warm. I have them plugged into a switched outlet on the pre-pro so they turn on when everything powers up. 3 Quote Link to comment Share on other sites More sharing options...
jimjimbo Posted October 7, 2015 Share Posted October 7, 2015 If you are going to install a cooling fan, you shouldn't have any problem at all. Quote Link to comment Share on other sites More sharing options...
CECAA850 Posted October 7, 2015 Share Posted October 7, 2015 Mount your fan on the uppermost portion of the cabinet and use it to exhaust (not take in) air. Be sure there is a way for cool (room temperature) air to get in the bottom. 1 Quote Link to comment Share on other sites More sharing options...
busht4169 Posted October 7, 2015 Share Posted October 7, 2015 Thermal limit for most amps in around 150-160 F. The problem with that is, depending on surrounding electronics, or materials you could damage plywood, plastics and such. Most amps auto shut-off before the limit, but never rely on that. See manufacturer manual, they usually list thermals. 1 Quote Link to comment Share on other sites More sharing options...
willland Posted October 7, 2015 Share Posted October 7, 2015 I have a Marantz SR 5008 HT reciever. Have had a new peice of AR furniture built to house it and other components. Using a heat gun I find that it seems to run between 105 and 120 f. I have a cooling fan unit on order which should be here anytime. How hot is too hot for this type of equipment? When I first bought my Onkyo TX-SR705 back in 2007, when pushed, it would operate at pretty high temps at around 145 F. Now I did not have much room(less than 2 inches) for the top to breath due to a low hanging shelf, so I bought a cooling fan and that did the trick. Now, it never gets above around 120 F. Get the cooling fan just to be safe. Bill 1 Quote Link to comment Share on other sites More sharing options...
jason str Posted October 7, 2015 Share Posted October 7, 2015 What feels too hot to the touch for us is probably not too hot for your electrical components. 2 Quote Link to comment Share on other sites More sharing options...
YK Thom Posted October 8, 2015 Author Share Posted October 8, 2015 I'll feel better once the fan (dual) arrive. Seems to be just over 100 with music and went up to 120 during a movie last night. As part of the design the bottom of the unit has multiple slots cut, almost like a grill. It is the same on all the other shelves. Quote Link to comment Share on other sites More sharing options...
wvu80 Posted October 8, 2015 Share Posted October 8, 2015 (edited) I'll feel better once the fan (dual) arrive. Seems to be just over 100 with music and went up to 120 during a movie last night. I don't know AVR temps but I do know PC temps can bump up to 140F with no problem. My gaming PC which I have running at standard clock speeds usually runs about 100 degrees. Does your manual list standard operating temperatures? Edited October 8, 2015 by wvu80 Quote Link to comment Share on other sites More sharing options...
Guest thesloth Posted October 8, 2015 Share Posted October 8, 2015 I use 105 degree celcius grade capacitors in all my applications, that's 221 degress fahrenheit operating temperature! Electronics get hot. A fan will help increase the life. Quote Link to comment Share on other sites More sharing options...
YK Thom Posted October 8, 2015 Author Share Posted October 8, 2015 I'll feel better once the fan (dual) arrive. Seems to be just over 100 with music and went up to 120 during a movie last night. I don't know AVR temps but I do know PC temps can bump up to 140F with no problem. My gaming PC which I have running at standard clock speeds usually runs about 100 degrees. Does your manual list standard operating temperatures? It does not seem to be indicated in the manual. Quote Link to comment Share on other sites More sharing options...
jacksonbart Posted October 9, 2015 Share Posted October 9, 2015 . Seems to be just over 100 with music and went up to 120 during a movie last night. Where you in or out of your clothes? Was the wife with you in such a condition? Was the movie considered "soft" or "hard". These factors have a lot of implications to the general temperature. But you know what? Its worth it. 1 Quote Link to comment Share on other sites More sharing options...
BigStewMan Posted October 9, 2015 Share Posted October 9, 2015 I have an older Yamaha HTR-5790 (I believe it is)...it gets pretty warm. Quote Link to comment Share on other sites More sharing options...
djk Posted October 9, 2015 Share Posted October 9, 2015 55°C (131°F) is the highest ambient temperature I would run consumer electronics without ventilation. We test at work to 70°C (158°C), but with lots of fan cooling. In general, life span gets cut in half every 10°C rise (above a certain point). Capacitors may be rated at 105°C (for a few hours anyway, maybe as little as 1,000 hours), read the spec sheets to see how long for sure. Quote Link to comment Share on other sites More sharing options...
Rdmarsiii Posted December 2, 2015 Share Posted December 2, 2015 My Krell has hit 208 degrees before. That scared me, called Krell, they said it was normal. Who knows. Quote Link to comment Share on other sites More sharing options...
djk Posted December 3, 2015 Share Posted December 3, 2015 (edited) Older Krells used 200°C rated Motorola transistors, they run just fine at junction temperatures of 100°C. Capacitorshave reduced life in amplifiers that run as hot as your Krell does. Edited December 3, 2015 by djk 1 Quote Link to comment Share on other sites More sharing options...
willland Posted December 3, 2015 Share Posted December 3, 2015 My Krell has hit 208 degrees before. That scared me, called Krell, they said it was normal. Who knows. A high class A bias amp like Krell designs are built to run at those temps. Bill Quote Link to comment Share on other sites More sharing options...
Arrow#422 Posted December 3, 2015 Share Posted December 3, 2015 Keep them under say 540 degrees F or your wooden AV rack will self combust. Quote Link to comment Share on other sites More sharing options...
Rdmarsiii Posted December 9, 2015 Share Posted December 9, 2015 Older Krells used 200°C rated Motorola transistors, they run just fine at junction temperatures of 100°C. Capacitorshave reduced life in amplifiers that run as hot as your Krell does. So should I be thinking of sending it in for a new cap job? I think it still has a year of warranty left... Quote Link to comment Share on other sites More sharing options...
xxJPMxx Posted December 9, 2015 Share Posted December 9, 2015 So should I be thinking of sending it in for a new cap job? I think it still has a year of warranty left... I highly doubt you can talk them into replacing any capacitors that haven't failed for free under warranty. Good luck! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.