Klipsch Pro Audio
Talk about our Pro Audio and Cinema products here.
1226 topics in this forum
-
- 0 replies
- 373 views
-
- 0 replies
- 401 views
-
- 0 replies
- 374 views
-
- 0 replies
- 374 views
-
- 0 replies
- 974 views
-
- 0 replies
- 482 views
-
- 0 replies
- 464 views
-
- 0 replies
- 858 views
-
- 0 replies
- 745 views
-
- 0 replies
- 1.1k views
-
- 0 replies
- 776 views
-
- 0 replies
- 581 views
-
- 0 replies
- 547 views
-
- 0 replies
- 657 views
-
- 0 replies
- 986 views
-
- 0 replies
- 640 views
-
- 0 replies
- 678 views
-
- 0 replies
- 1.1k views
-
- 0 replies
- 707 views
-
- 0 replies
- 1.5k views
-
- 0 replies
- 716 views
-
- 0 replies
- 701 views
-
- 0 replies
- 971 views
-
- 0 replies
- 840 views
-
- 0 replies
- 791 views
-
Recent Posts
-
Just wanted to update everyone who helped out with this thread! I was able to replace the gasket on the midrange drive and the distortion is gone! Thanks to the group for their input! GS -
By 82 Cornwalls · Posted
Some (recorded) music is very dynamic, so how much more do I need if 1/4 watt average? -
If you’re hoping for an answer or to educate the OP with your findings, they haven’t been on the forum since October of 2008. -
BR on the serial rag devotees Birch Raw. In other words, everything that you see that makes it look different than a typical Klipschorn was done after it left the factory.
-
-
Thanks @nickyboy6100 If interested, I can meet you half way! -
-
I have recently acquired a beautiful pair of Klipschorn Khorn. The design is different than others I have seen. I know they are Birch Veneer. 1. The entire cabinet is enclosed 2. There is a relief carved ornamental rectangle on the front panels 3. There are large moldings on the bottom and about 4. It all seems to be from the manufacturer since it all looks like the same wood and design. See the photos attached. Questions: 1. Was this custom-made by Klipch from the factory since it all seems to match perfectly? 2. It is missing the OEM emblems, are they still available for purchase? 3. Is there anything else special about this pair of Khorns? Thank you for any help or insight... kind regards, Richard -
dawaro: I've been doing research to find the v.2-400 DIN layout and have been advised by someone else in the forum (from 2008) that the v.2-400 DIN has at least 5 different wiring setups. To make matters worse, if you pick the wrong sequence you'll blow amps and the woofers. (Probably by accidentally connecting the power supply to an amp input.) Going the DIY route, It turns out that the connections in the subwoofer are buried so tight against the back panel by the amplifier chassis that you can't get to the wires with a VOM with disassembling it. So, I'm wiring up an 8-pin plug and socket as an open extension so I can determine the wiring sequence myself. -
-